AC Circuits

Simple Tranformerless Power supply


It is very easy to convert 220 Volt AC to DC for powering electronic circuits. Any DC voltage from 3 volt to 36 volt can be generated from 220 volt AC using appropriate value of X rated capacitor and Zener diodes. The X rated capacitor drops 220 V AC to low volt AC. This can be rectified to DC by a Rectifier diode and smoothed by a Filter capacitor. By selecting a required value Zener, regulated DC can be obtained. But the only drawback of the Tranformerless power supply is its low current, so only light loads can be used. Here explains the design of a 4.7 Volt 4.6 Milli Ampere Tranformerless power supply to power PIR sensor .

Continue reading “Simple Tranformerless Power supply”

Advertisements
Components, Electronics, Electronics Theory, Home Circuits, How components work, Power Supply, Techniques, Utility Gadgets

AC Powered PIR Light


A Simple design of PIR Light using Tranformerless Power Supply and Triac for driving the load. Too compact and can be enclosed in a small case. The light turns on when the PIR sensor detects human movement and turns off after the preset time. Re triggers in another movement. Its range is 30 cm to 10 meters and time delay, 30 seconds to 3 minutes both can be adjusted using the presets in the PIR sensor Module.

Continue reading “AC Powered PIR Light”

Chargers

Fast Charger for Car battery



Here is an efficient Car battery charger for fast charging the Car battery. It is a 5 Ampere charger with Digital Volt and Ampere Meter to display the charging voltage and current. Since the charger provides maximum 5 Amps current, battery can take high current it needs to charge very fast. As the charging process completes, current flow reduces to zero and will be displayed in the meter. So it is easy to confirm whether the battery is fully charged or not.
Continue reading “Fast Charger for Car battery”

Chargers

How to connect Panel Meter in Battery Charger



Digital Volt Ampere Meters are now available which can be used in Battery chargers to monitor voltage and current. One section of the Meter displays 0 to 100 V DC and the second section displays current 0 to 10 Amperes. The Meter works off 4 to 30 V DC. Let us see how it can be used in a charger….
Continue reading “How to connect Panel Meter in Battery Charger”

Chargers

Automatic Car Battery Charger


This 5 Amps charger automatically stops charging when the terminal voltage of battery rises to 13.7 V thus preventing over charging. If the battery voltage drops below 11 V, Charger turns on and starts charging. Check it……….
Continue reading “Automatic Car Battery Charger”