Alarm for Water Heater


It was a big problem in my house that, sometimes the Water heater left on for many hours after the use. It has a Thermostat to cut off but when the water cools, again it switches on. This causes hike in electricity bill. Finally I found a solution. Just connected a Timer based alarm with the heater AC socket so that it will also switches on when the heater turns on. After 30 minute, it gives a loud alarm to remind that the heater is On. Alarm continues for another 30 minutes or till the heater is switched off. So that alarm reminds to switch off the water heater. This can be used for Electric Iron also.

To make the circuit compact, I used a Transformerless power supply using an X-rated 474 capacitor. The rectified DC is around 20 volts ,so I used a 7812 voltage regulator to give stable 12 volts for the circuit. Green LED indicates the power on status. I used the Binary counter IC CD 4060 to give alarm after 30 minutes. It has 10 outputs which turn high one by one when the IC starts oscillating with resistor R5 and capacitor C6. The reset pin 12 of IC is connected at the junction between C5 and R4 so that the IC resets at power on and starts oscillating. Blinking of Yellow LED connected to the first output pin 7 indicates the oscillation of IC. After 30 minutes, pin2 of IC turns high and transistor T1 conducts, Red LED turns on and buzzer beeps. I used a small PCB type buzzer working between 3-12 volts but it’s sound is very high to catch attention even from outside the home.

 

I enclosed the circuit in a Plastic case with holes for the LEDs and Buzzer. Two high gauge wires for Phase and Neutral were soldered with the circuit and connected the other ends to the Phase and Neutral pins of the AC socket for the heater. So the circuit switches on along with the heater.

Caution: Even though I used a Transformerless power supply, a 9 volt transformer based power supply can be used. Transformerless power supply is dangerous if handled carelessly. It can give a fatal shock. So do not try it if you are not competent to deal with high volt AC. Use a transformer for the power supply for safety.

 

Advertisements

Add your Comments here and Click Post Comment. For Queries, come to the Discuss and Share Forum

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s