Remote Tester using TSOP 1738. Sensor Circuit .16


Remote hand sets of TV, VCD player, Home Theater system etc uses Infrared rays pulsating at 38 kHz. So in the receiver section, there is an Infrared receiver to receive the coded IR pulses. In most cases the 38 kHz IR module TSOP 1738 is used as receiver which is specific for 38bkHz IR rays. This module has a PIN photodiode and a pre amplifier stage enclosed in an epoxy case which acts as a filter and passes only IR rays. Its output is active low and gives + 5 V DC in the stand by state. The circuitry inside of the module amplifies the coded pulses from the IR transmitter. From the PIN Photodiode,  the coded signals pass into an Automatic Gain Control (AGC) stage and then into a Band pass filter. Finally a Demodulator demodulates the signals and sends to the output transistor which forms the output. So when the module gets coded signals, the output transistor sinks current.

Continue reading

Advertisements